Creative Reusable Things To Do With a Damaged Pine Tree

Creative Reusable Things To Do With a Damaged Pine Tree

Pine trees are evergreens that are hardy in harsh weather and withstand many of Mother Nature’s assaults. These trees often grow very large and tall, depending on the species. When they are struck by lightning or lose limbs in hurricanes and snowstorms, the leftover materials are often so extensive that they can overwhelm even the most yard-savvy homeowner. Finding uses for pine cones, needles, branches and entire trees requires some creativity of uses or large vehicles for costly disposal. If the tree is damaged and needs to be cut down, use a chainsaw to do so. If there is just a broken branch or two, the limbs can be cleaned up for a clean finish using a chainsaw or pole saw to prevent insect damage.

One of the most popular ideas people have for using downed pine trees and limbs is for firewood. Pine chips and logs are practical for outdoor fire pits, chimineas and campfires, where creosote is not an issue. Using any type of pine is not a good idea for interior chimneys. Creosote builds up on the interior chimney walls. When it becomes heavy enough, sparks from routine fires in the bottom of the chimney can ignite the creosote on the upper chimney walls, causing a house fire.

Use pinecones spread with peanut butter and dipped in birdseed to make a tasty snack for the local birds. Tie a string around one end of the pinecone and the other end around a branch.

For a more formal birdhouse, cut wood pieces with a chainsaw and hollow out the interior with a chisel or long saw blade. Use sandpaper to smooth out the edges. Attach floor and roof slabs to the birdhouse with sturdy nails. Use bark-coated pieces for decorative rainwater protection on the roof. Fashion a pine perch in front of the entry hole. Use a sturdy wire to hang it up or erect a birdhouse post for it. Put it in a place safe from predators and severe weather.

Use a wide half-moon shaped pine log from the trunk to create a swing. While a chainsaw is helpful for taking the tree down, it may be easier to craft the swing from a stationary saw. The seat can be a half circle or vertical flat slab. Use a sander to smooth out the surface and remove any potential splinters. Create two notch holes evenly spaced from the ends. Feed strong nylon rope through the holes and tie a secure knot through the ends. Install the swing on a sturdy branch of a strong tree. The swing should hang low enough for the feet to just drag on the ground when passing through at the lowest point. Check on the weight provisions for the rope following manufacturer’s packaging instructions. Inspect the swing and rope regularly for nicks, frays and splinters.

Feed any branches or unusable pieces into a wood chipper to create mulch. Allow the chips to season when possible for best results. Dried pine needles, called pine straw, make a practical mulch alternative in beds flower beds and around trees and bushes that prefer acidic soil. It helps to keep the moisture in and prevents weeds and grass from growing in these areas. The straw can be easily corralled into fluffy piles with a leaf blower or rake.

Evenly cut a large segment of pine trunk with a chainsaw or stationary saw to create a table. Level and smooth out the top and bottom surfaces. Stain the top if desired. Add stickers, dried leaves and other items to the stump surface for decoration if desired before applying a few coats of polyurethane on top.

Author is a freelance writer. For more information on Chainsaw please visit

Leave a Reply

Your email address will not be published. Required fields are marked *